Building a club house/tree house/play house in our backyard
Difficulty Level (Easy, Medium, Hard, Insane):
Medium
Process:
The process was fairly straight forward. The first part was similar to building a deck, the second one was more like building a garden shed. The summary steps were as follows:
1. Drill 6holes
2. Set 6 4x4 posts
3. Frame the 8'x12' platform
4. Frame the 6'x8' play house
5. Build 3' railing
6. Shingle the roof
7. Frame the window and door frames
8. Install the soffits and facia
9. Install the cedar siding
Videos:
Pictures:
 |
| Front and side view plan |
 |
| Framing plan for club house |
 |
| The calculations for installing the high pressure air piston for the trap door to the upper level |
 |
| Digging the holes for the posts |
 |
| 4x4 posts installed and Nathaniel with his friend inspecting the work |
 |
| Building the frame for the platform |
 |
| Adding the floor joists |
 |
| The A-frame for the end of the zip line (this is version 2) |
 |
| After cutting the 6x6 posts for the end of the zip line |
 |
| A view from the deck to the club house/zip line platform |
 |
| Building the end of the zip line (this is version 3) |
 |
| Splitting the 3/8" aircraft steel wire in half |
 |
| Unwinding 7 turns to get ready for the Flemish eye termination |
 |
| Re-winding the wire to form a loop (Flemish eye) |
 |
| The finished Flemish eye |
 |
| After adding the thimble and two cable clamps finish the end of the wire |
 |
| Framing one of the club house walls |
 |
| Another wall (side) |
 |
| The front wall with the two windows (1st storey & 2nd storey) |
 |
| Hauling the framed walls up to the platform |
 |
| Assembling them together |
 |
| After the sheathing was done |
 |
| Some trigonometry to calculate the length of the diagonal cut on the roof joists (just for fun) |
 |
| Framing one half of the roof |
 |
| One roof section framed and sheathed |
 |
| Adding the tar paper and the drip edge |
 |
| Roofing the bottom few runs of shingles. Note to self: NEVER, EVER, EVER shingle a roof on the ground again. This sucker was so heavy, me and a 280 lbs army dude neighbor could barely lift them up onto the play house |
 |
| Ladder to the upper storey |
 |
| A view from the top. My eyes were about 15 feet off the ground |
 |
| Taking a break to enjoy the view |
 |
| My neighbor and I struggling to get the roof sections up; they must have weighed about 300-350lbs each! |
 |
| Nate checking out the top level |
 |
| And then doing a zip line run |
 |
| Another view from our deck |
 |
| After I built the back stairs |
 |
| Th roof is up and getting ready for the railing |
 |
| The house wrap is done and the railing as well |
 |
| A view from the back after I put up the corner trims |
 |
| The front after the corner trims and window jambs were installed |
 |
| Close-up of the soffit and underlying construction |
 |
| After the wood was painted with charcoal semi-transparent deck stain |
 |
| Another view from the front |
 |
| And a view from the rear |
 |
| I think it looks pretty cool |
 |
| I borrowed a friend's truck to drive about half an hour outside of Moncton (Havelock) to pick up some cedar slabs. This entire load only cost me $40 (plus $32 in gas for the truck!) |
 |
| Starting to put up the siding. I wanted it to look like a swiss hunters cabin |
 |
| After the front and side were done |
 |
| After the rear was done |
 |
| Another view from the front. I love it and I love seeing the kids enjoy it every day! |
Tools:
Hydraulic post hole auger (rental)
Chop saw
Table saw
Drill & drill bits
Angle grinder
MIG welder
Nail gun
Compressor
Measuring tape
Pencil
Chalk line
Level
Hammer
Drill press
Hole saw kit
Framing square
Jig saw
Circular saw
Roofing nailer
Tin snips
C-clamps
Ratchet straps
6' Ladder
Extension ladder
Hand stapler
HVLP spray gun
Knife
Chain saw
Wheel barrow
Shovel
Crow bar
Shop vac
Flashlight
Oxy-Acetylene torch
Adjustable wrenches
Socket set
Marker
Router
Saw horses
Extension chords
Materials:
Too much lumber to list
11 sheets of OSB for sheathing
100' of 3/8" aircraft grade steel cable
A bunch of pulleys, shackles and a turnbuckle
Some chain
2 gal of stain,
House wrap left over from the Work Shop Project
Old tire (for zip line stop)
Some rope
Zip Line Trolley
Tar paper
4 packs of shingles
Soffit, facia, drip edge
Cedar slabs for siding
Cost:
$2,200.00
Time:
100-150hrs (I wasn't keeping track)
Conclusion:
It has gotten SO much use out of it that it was and still is definitely worth it
